Here is a nice wireless 12 channel controller and receiver. check out the video below.
Key Features of the 12A
To program it first plug it into 12 volts. then press and hold for 3 seconds the little white button on the reviver board. then press button 1 a few times it will go into momentary mode.
for toggle mode hold down the white button on the receiver board for 3 seconds then press button 9 a few time this will put it in toggle mode.
check out the video below.
- Three modes: Toggle, Momentary,
- Encode/Decode to avoid interference
- Individual relay
Specification
- Distance: 100M(300 feet)
- Power supply: 12V
- Encode/Decode: Yes(Learning Code)
- Control Type: Quad mode:( Momentary, Toggle, Latch, )
- Relay: 10A/125VAC, 10A/14V DC
- Receiver Board Size: 8cm x 10cm x 3cm Remote
- Size: 5cm x 12.5cm x 2cm
Modes:
- Toggle: Press=On, Press again=Off
- Momentary: Press=On, Release=Off
Description: | 12 Channel RF Controller |
---|---|
Channel: | 12 |
Frequency: | 433MHz |